Anduril UI · Anduril 1 · Anduril 2 · Emisar D4V2
Make Anduril lights safe and simple to gift →

Anduril 2: Configure Ramp Ceiling (Maximum) Brightness

flashlights
anduril ui • anduril 2

This page refers to features of Anduril 2.

You may be looking for the Anduril 1 manual or Check if you're running Anduril 1 or 2.

Enter Advanced UI and enable the ramp you’d like to configure

To start, make sure you’ve enabled the ramp you’d like to configure: smooth or stepped.

When the light is on in the Advanced UI’s Ramping Mode, you can toggle between the ramps with: 3C.

Set ceiling to the maximum brightness

Stay in Advanced UI and proceed with the following steps.

  1. Enter Ramp Config Mode:
    • To configure the Advanced UI ramp:
      1. Enable Ramp Mode with 1C.
      2. 7H and keep holding it!
    • To configure the Simple UI ramp:
      1. Turn the light to Off.
      2. 10H and keep holding it!
  2. You’re now in Ramp Config Mode.
  3. While you’re still holding the button, you’ll notice the light flash almost immediately after the last button press. Keep holding until you see a second flash. After this second flash, let go. The light will begin a buzz (flash flickering), which signals that the light is ready to accept your input.
  4. Enter: 1C.
  5. The light will continue buzzing and then stop and return to Ramping Mode with a steady light.
flowchart TD A((OFF)) -->|1C| B1(Ramping Mode) B1 -->|7H| B2[Configure\nAdvanced UI Ramp] A -->|10H| C[Configure\nSimple UI Ramp] B2 --> D(Ramp Config Mode) C --> D D -->|Wait for 2 blinks| E[Ramp Ceiling Input:\nBuzzing light] E -->|1C| F[Buzzing light] F --> G[Steady light] subgraph "Advanced UI" A B1 B2 C RC G end subgraph RC[" "] D E F end style A fill:#000,color:#fff

Good work, you’ve configured your Anduril 2 light’s Ramping Mode’s ceiling to use the maximum brightness.

Set ceiling to another brightness

If you’d like your ceiling to be a little less bright, instead of 1C as the input above, you can click to set the level you’d like for your ramp:

Clicks 1 2 3 … 150
Ceiling Level 150/150 149/150 148/150 … 1/150

See also

Gifting flashlights for family and friends?

Anduril Builder creates custom firmware with only the modes you pick. No turbo burns, no strobe surprises.

Build a simpler light →

Buy me a coffee?

Thank you for reading! If you found this useful, consider supporting my writing and indie app work with a small one-time donation through Buy Me a Coffee. Thanks!

Buy Me a Coffee